系統版本
[root@ ~]# cat /etc/redhat-release
CentOS release 6.8 (Final)
[root@ ~]# uname -r
2.6.32-642.6.1.el6.x86_64
網卡說明
eth0?? 192.168.1.8（服務器外網卡）
eth1?? 服務器網卡(內網)
eth2?? 服務器網卡(內網)
[root@ ~]# /etc/init.d/iptables stop
[root@ ~]#? chkconfig iptables off
關閉selinux
[root@ ~]#setenforce 0
[root@ ~]#sed -i ‘s/SELINUX=enforcing/SELINUX=disabled/‘ /etc/selinux/config
禁用NetworkManager
[root@ ~]# /etc/init.d/NetworkManager stop
Stopping NetworkManager daemon:?????????? [? OK? ]
[root@ ~]# chkconfig NetworkManager off
[root@ ~]# /etc/init.d/network restart
雙網卡綁定配置過程
[root@ ~]# cd /etc/sysconfig/network-scripts/
編輯eth1網卡
[root@ network-scripts]# cat >ifcfg-eth1 <> DEVICE=eth1
> ONBOOT=yes
> BOOTPROTO=none
> USERCTL=no
> MASTER=bind0
> EOF
編輯eth2網卡
[root@ network-scripts]# cat >ifcfg-eth2
ONBOOT=yes
BOOTPROTO=none
USERCTL=no
MASTER=bind0
EOF
編輯bind0網卡
[root@ network-scripts]# cat >ifcfg-bind0 <> DEVICE=bind0
> TYPE=Ethernet
> ONBOOT=yes
> BOOTPROTO=none
> IPADDR=10.0.0.8
> NETMASK=255.255.255.0
> GATEWAY=10.0.0.254
> IPV6INIT=no
> USERCTL=no
> EOF
配置bond參數
[root@ network-scripts]# cat >/etc/modprobe.conf <> alias bind0 bonding
> options bind0 miimon=100 mode=6
> EOF
加入開機自啟動(/etc/rc.local)
[root@ network-scripts]# cat >>/etc/rc.local <> ifenslave bind0 eth1 eth2
> EOF
重啟網絡服務
[root@LVS-2 network-scripts]# service network restart
Shutting down interface eth0:????????????????????????????? [? OK? ]
Shutting down interface eth1:????????????????????????????? [? OK? ]
Shutting down interface eth2:????????????????????????????? [? OK? ]
Shutting down loopback interface:?????????????????????? [? OK? ]
Bringing up loopback interface:??????????????????????????? [? OK? ]
Bringing up interface bind0:? WARNING: Deprecated config file /etc/modprobe.conf, all config files belong into /etc/modprobe.d/.
WARNING: Deprecated config file /etc/modprobe.conf, all config files belong into /etc/modprobe.d/.
Determining if ip address 10.0.0.8 is already in use for device bind0..[? OK? ]
Bringing up interface eth0:? Determining if ip address 192.168.1.8 is already in use for device eth0...???????????????????????????????????????????????????? [? OK? ]
Bringing up interface eth1:? RTNETLINK answers: File exists???????? [? OK? ]
Bringing up interface eth2:? RTNETLINK answers: File exists????????? [? OK? ]
配置使綁定立即生效
[root@LVS-2 network-scripts]# ifenslave bind0 eth1 eth2
測試聯通
[root@LVS-2 network-scripts]# ping 10.0.0.8
PING 10.0.0.8 (10.0.0.8) 56(84) bytes of data.
64 bytes from 10.0.0.8: icmp_seq=1 ttl=64 time=0.089 ms
64 bytes from 10.0.0.8: icmp_seq=2 ttl=64 time=0.046 ms
^C
--- 10.0.0.8 ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 1921ms
rtt min/avg/max/mdev = 0.046/0.067/0.089/0.023 ms
此時會發現系統多一個網卡
[root@LVS-2 network-scripts]# ifconfig bind0
bind0
Link encap:Ethernet? HWaddr 00:0C:29:CC:9B:5
inet addr:10.0.0.8? Bcast:10.0.0.255? Mask:255.255.255.0
inet6 addr: fe80::20c:29ff:fecc:9b55/64 Scope:LinkUP BROADCAST RUNNING MASTER MULTICAST? MTU:1500 Metric:1
RX packets:151 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:11826 (11.5 KiB)? TX bytes:258 (258.0 b)
